New parameter
-
Gabriela Arroyo
- Posts: 5
- Joined: May 30 2019
- Affiliation: IFM UMSNH
Post
by Gabriela Arroyo » July 17 2019
Hi there! I added some new parameters in the camb code packaged in cosmomc. Then I compiled the code and for example when I run:
at the end of the output I have
Code: Select all
forrtl: severe (174): SIGSEGV, segmentation fault occurred
forrtl: severe (174): SIGSEGV, segmentation fault occurred
forrtl: severe (174): SIGSEGV, segmentation fault occurred
The same if I run
I don't have any idea what is wrong.
-
Antony Lewis
- Posts: 1943
- Joined: September 23 2004
- Affiliation: University of Sussex
-
Contact:
Post
by Antony Lewis » July 18 2019
make cosmomc_debug then try to track it down using that.
-
Gabriela Arroyo
- Posts: 5
- Joined: May 30 2019
- Affiliation: IFM UMSNH
Post
by Gabriela Arroyo » July 18 2019
make cosmomc_debug output:
Code: Select all
ifort: warning #10182: disabling optimization; runtime debug checks enabled
make[1]: se sale del directorio '/home/gaby/works/CosmoMC-master/source'
then I did
./cosmomc_debug test.ini
and the output contains the lines:
Code: Select all
forrtl: severe (408): fort: (3): Subscript #1 of the array Y has value 0 which is less than the lower bound of 1
forrtl: severe (408): fort: (3): Subscript #1 of the array Y has value 0 which is less than the lower bound of 1
forrtl: severe (408): fort: (3): Subscript #1 of the array Y has value 0 which is less than the lower bound of 1
-
Gabriela Arroyo
- Posts: 5
- Joined: May 30 2019
- Affiliation: IFM UMSNH
Post
by Gabriela Arroyo » July 21 2019
Just to explore what's happening I compiled camb with my new parameter fixed in equations_ppf, but again the result of ./camb params.ini gives:
Code: Select all
forrtl: severe (174): SIGSEGV, segmentation fault occurred