running CAMB in parallel on multiple cores
Posted: September 21 2007
I'm trying to get CAMB to run on both cores of a Macbook Pro, using the default Makefile setup:
#Intel 8 , -openmp toggles mutli-processor:
F90C = ifort
FFLAGS = -ip -O2 -Vaxlib -W0 -WB -fpp2 -openmp
The code compiles, but when running I get the following error:
lap~/NUMERICS/CAMB>./camb params.ini
dyld: Library not loaded: libguide.dylib
Referenced from: /Users/oliverzahn/NUMERICS/CAMB/./camb
Reason: image not found
Trace/BPT trap
Any idea on what is going wrong?
Without the -openmp flag, the code runs fine on my Mac, however of course only on one core.
Oliver
#Intel 8 , -openmp toggles mutli-processor:
F90C = ifort
FFLAGS = -ip -O2 -Vaxlib -W0 -WB -fpp2 -openmp
The code compiles, but when running I get the following error:
lap~/NUMERICS/CAMB>./camb params.ini
dyld: Library not loaded: libguide.dylib
Referenced from: /Users/oliverzahn/NUMERICS/CAMB/./camb
Reason: image not found
Trace/BPT trap
Any idea on what is going wrong?
Without the -openmp flag, the code runs fine on my Mac, however of course only on one core.
Oliver