Varying Helium fraction

Use of Cobaya. camb, CLASS, cosmomc, compilers, etc.
Post Reply
Sunny Vagnozzi
Posts: 55
Joined: August 15 2016
Affiliation: Kavli Institute for Cosmology (KICC), University of Cambridge

Varying Helium fraction

Post by Sunny Vagnozzi » April 14 2021

Hi Antony and all,

a quick question regarding varying the Helium mass fraction. Have I understood correctly that, if I want to do this, I should first of all switch off bbn_consistency, i.e. in params_CMB_defaults.ini

Code: Select all

bbn_consistency = F
and then just set the prior ranges for the parameter y_he as I would usually do, e.g.

Code: Select all

param[yhe] = 0.24 0.20 0.28 0.01 0.01
(the numbers I set are just for indicative purposes), where setting bbn_consistency to False is necessary to avoid bbn_consistency otherwise overwriting my prior on the Helium mass fraction? On a related note, say I were using only Planck data (TTTEEE+lowl+lowE), what would be reasonable values for the minimum and maximum ranges for yhe, and the proposed step size? I see the Planck public chains used

Code: Select all

param[yhe] = 0.245 0.1 0.5 0.006 0.006
is that what you would recommend?


Antony Lewis
Posts: 1765
Joined: September 23 2004
Affiliation: University of Sussex

Re: Varying Helium fraction

Post by Antony Lewis » April 18 2021

The Planck chain settings should be fine.

Post Reply