[CosmoMC] Delays in Planck 2018 with same 15 configuration
Posted: September 03 2019
Dear all,
I apologise for the various posts however I think this might just caption some issues that might hopefully help others as well.
I've ported all the batch3 files and installed Planck 2018, as recommended by the Plik readme and Antony, and attempted runs of some parameter scenarios from 2015 data, with the 2018 data. I have noticed that these runs are taking a suspiciously longer amount of time to run than the 2015 runs. For example, these runs that would have taken a day with Planck 2015, doesn't even close below a convergence of 1 after a day in the 2018 case.
Numerous issues which I'm not sure are potential causations:
- With 2015, I used lowTEB instead of the commander lowE + lowl combination
- I am Stil currently using the base planck TTTEEE+lowTEB+lensing covmat for the proposal distribution.
Otherwise I don't really know what could be causing the slowdown..
Any ideas would be gratefully received :)
Luke
I apologise for the various posts however I think this might just caption some issues that might hopefully help others as well.
I've ported all the batch3 files and installed Planck 2018, as recommended by the Plik readme and Antony, and attempted runs of some parameter scenarios from 2015 data, with the 2018 data. I have noticed that these runs are taking a suspiciously longer amount of time to run than the 2015 runs. For example, these runs that would have taken a day with Planck 2015, doesn't even close below a convergence of 1 after a day in the 2018 case.
Numerous issues which I'm not sure are potential causations:
- With 2015, I used lowTEB instead of the commander lowE + lowl combination
- I am Stil currently using the base planck TTTEEE+lowTEB+lensing covmat for the proposal distribution.
Otherwise I don't really know what could be causing the slowdown..
Any ideas would be gratefully received :)
Luke