Hi ,
When introducing the a new variable and its prior in params_CMB_default.ini, we have the following format.
center, min, max, start width, propose width
this I assume is a flat prior. Why are we entering a Center value when max and min are given? Is there some special reason for inputting this ?
The reason I ask is because when I make the likelihood plot for my new variable , I see my peak is always near the center value I enter.
Any Insight is appreciated.
Thanks
Nishanth
Prior question
-
- Posts: 27
- Joined: September 07 2016
- Affiliation: university of notre dame
-
- Posts: 1943
- Joined: September 23 2004
- Affiliation: University of Sussex
- Contact:
Re: Prior question
Chains have to start somewhere, so it uses centre as a central estimate (and disperses start points about that depending on the start width). The final answer once converged should be independent of it, just convergence will be faster if it's not too far off.
Make sure your propose width is small enough that the parameter is moving, otherwise it will take ages to converge.
Make sure your propose width is small enough that the parameter is moving, otherwise it will take ages to converge.
-
- Posts: 27
- Joined: September 07 2016
- Affiliation: university of notre dame
Prior question
If my range is between 0 and 6 , is this a good start and propose width
center min max start propose
3.00 0.00 6.00 0.001 0.001
Thanks
Nishanth
center min max start propose
3.00 0.00 6.00 0.001 0.001
Thanks
Nishanth