axionCAMB and cosmomc: how to transfer the CAMB params to CM
Posted: April 06 2017
Hi,
I tried to link cosmomc with axionCAMB, a modified code of the old camb in cosmomc which adds something about ultra-light axions.
I have added the two new initial params(m_ax and omaxh2) to cosmomc successfully. But it stopped when the file named *.out showed as follows :
...
max_eta_k = 14000.00
transfer kmax = 5.000000
adding parameters for: lowl_SMW_70_dx11d_2014_10_03_v5c_Ap
adding parameters for: plik_dx11dr2_HM_v18_TT
Fast divided into 1 blocks
23 parameters ( 9 slow ( 0 semi-slow), 14 fast ( 0 semi-fast))
Maybe it occurred because some params about axions are not included in cosmomc. Then I want to transfer them from axionCAMB to CMB because they have been defined and calculated in axionCAMB. So can you guys tell me where I should modify the code in cosmomc/source to do it?
Tksï¼
I tried to link cosmomc with axionCAMB, a modified code of the old camb in cosmomc which adds something about ultra-light axions.
I have added the two new initial params(m_ax and omaxh2) to cosmomc successfully. But it stopped when the file named *.out showed as follows :
...
max_eta_k = 14000.00
transfer kmax = 5.000000
adding parameters for: lowl_SMW_70_dx11d_2014_10_03_v5c_Ap
adding parameters for: plik_dx11dr2_HM_v18_TT
Fast divided into 1 blocks
23 parameters ( 9 slow ( 0 semi-slow), 14 fast ( 0 semi-fast))
Maybe it occurred because some params about axions are not included in cosmomc. Then I want to transfer them from axionCAMB to CMB because they have been defined and calculated in axionCAMB. So can you guys tell me where I should modify the code in cosmomc/source to do it?
Tksï¼