Hi everyone,
I am using the GetDistGUI.py for plotting results. When it loads chains it ends with the following comment, removed no burn in. Does anyone know what is a good burn in value to remove , is .5 good enough?
Thanks
Nishanth
Burn in percentage
-
- Posts: 27
- Joined: September 07 2016
- Affiliation: university of notre dame
-
- Posts: 1951
- Joined: September 23 2004
- Affiliation: University of Sussex
- Contact:
Re: Burn in percentage
I use 0.3 for standard cosmomc chain run settings (set in GetDistGui's Options, Analysis settings).
(note Planck chains are supplied with burn-in already removed)
(note Planck chains are supplied with burn-in already removed)